Material: Stainless steel 1.4401 (AISI 316).

Clamping bush for lower torques; not self-centering.

Fit: Shaft h8, Hub H8. Surface roughness R_z max. 16 µm.

Mounting: Slightly oil the clamping set before mounting, do not use molibdenum disulphide or grease. Tighten the screws evenly and crosswise in several steps. Demounting: Due to the cone angle, the clamping set is usually released once all screws have been fully unfastened. There a three large threads cut into the front ring, which serve to remove this ring.

Ts - Fastening Torque

T - Transmittable Torque

F - Transmittable Axial Force

P - Surface Pressure onto Hub